Software includes three-phased insurance-processing system

June 1, 1996
Practice Outlook,® Inc. announces the introduction of the latest enhancement to its complete, computer-software packing for the dental office-a three-phased insurance-processing system. Versions 6.12, 6.20 and 6.30 consist of on-line storage and retrieval of insurance forms, electronic claims-processing and enhanced insurance-estimating capabilities, providing practices with increased productivity and cost savings.

Practice Outlook,® Inc. announces the introduction of the latest enhancement to its complete, computer-software packing for the dental office-a three-phased insurance-processing system. Versions 6.12, 6.20 and 6.30 consist of on-line storage and retrieval of insurance forms, electronic claims-processing and enhanced insurance-estimating capabilities, providing practices with increased productivity and cost savings.

For details or to arrange for a demonstration disk, contact Joe Shuster at (800) 247-6173 or circle the number below on the reader service card.

PRACTICE OUTLOOK,® INC.

Sponsored Recommendations

Clinical Study: OraCare Reduced Probing Depths 4450% Better than Brushing Alone

Good oral hygiene is essential to preserving gum health. In this study the improvements seen were statistically superior at reducing pocket depth than brushing alone (control ...

Clincial Study: OraCare Proven to Improve Gingival Health by 604% in just a 6 Week Period

A new clinical study reveals how OraCare showed improvement in the whole mouth as bleeding, plaque reduction, interproximal sites, and probing depths were all evaluated. All areas...

Chlorine Dioxide Efficacy Against Pathogens and How it Compares to Chlorhexidine

Explore our library of studies to learn about the historical application of chlorine dioxide, efficacy against pathogens, how it compares to chlorhexidine and more.

Enhancing Your Practice Growth with Chairside Milling

When practice growth and predictability matter...Get more output with less input discover chairside milling.